Kohler Power 30kW Liquid Cooled Dual Fuel Standby Generator Single-Phase (120 / 240V) with Block Heater

30kW LP/NG  |   120/240 Volts  |   Single Phase  |   Quiet 60dBA Operation    

Engine Block Heater  |  18-Inch to Home Install   |  181 MPH Wind Rating  |   RDC2 Controller

The Kohler 30kW Generator provides high quality power with advanced voltage and frequency regulation and low harmonic distortion. Neighborhood friendly operation at 60 dBA and 52 dBA during exercise. The Liquid Cooled Kohler 2.2 Liter turbocharged Inline 4 cylinder engine provides plenty of power at 1800 RPM. The electronic governor maintains frequency within 1%. From No Load to a Full Load Condition, Total Harmonic Distortion (THC) is less than 5%.

Features a factory installed thermostat controlled Engine Block Heater for regions that fall below 32° Fahrenheit.

Meets US EPA, California, and Massachusetts emissions requirements. UL-2200 Listed.

The 30kW Kohler Generator powers all the appliances for home or business including air conditioning, heating, lights, security, and office equipment. Seconds after an outage turns out the lights, the 304RCLA restores power. Runs on Natural Gas or Propane. Includes Kohler Home Energy Management.

Kohler's Premium Limited Warranty Covers Parts, Labor, and Travel for 5-Years/2000-Hours.

Made in the USA-The 30kW Kohler Generator is manufactured in the United States.

30kW Kohler Generator Features

• Aluminum Sound Enclosure + Silencer
• Factory Installed Engine Block Heater
• UL-2200 Listed
• GFCI Service Outlet 120/240 Volt
• Integral Vibration Isolation
• Oil Drain Extension
• NEC Prime Mover Shutdown Switch
• Remote Monitoring & Control of Generator & ATS System
• RDC2 Controller + Built-In Battery Charger

30kW Generator RDC2 Digital Controller

The digital controller manages all aspects of the standby generator system. 

Some controller features apply only to use with an RXT Transfer Switch. Please see the specifications for RDC2 Controller Features and the Owner Manual for a detailed explanation and implementation of controller features.

Main RDC2 Features Include:

• Membrane Keypad
• LED Indicators
• 2 Line Backlit LCD Screen with contrast control.
• Digital isochronous governor maintains speed at all loads.
• Digital voltage regulation ±1% from no load to full load
• Programmable exerciser
• Ethernet connector
• Diagnostic Messages and Maintenance Reminders
• ATS Status and Control (this feature requires an RXT transfer switch)
• Programmable Interface Module (PIM) Status

Specifications